• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Making this rack and need it to be pre......

R

reptile_addict

New member
Making this rack and need it to be pre approved. I will paste it below



A 24" by 13" base which will hold 3 tubs. They are the 1.4 gal. Rubbermaids.
Above that will hold 3 and so on til I have 15 total. It will be heated by 11" flexi going up the middle of the back. It will be small and I am making another rack after this for 4.5 gallon boxes. Any suggestions on this?
 
You must log in or register to reply here.
Back
Top