• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

My freakin thermo!!!!

X

XxRachxX

New member
hiya i have a habistat dimmer thermostat and basically it sucks!!!! i set it at around 87F cuz my baby's in a tub inside his viv. I check it everyday and every so often the temp goes up to around 93F!!! The sensor is placed on the bottom of the viv next to his tub? any tips on where to place it so it reads the right temp?? anybody had these problems with their thermostat?? i think im doing something wrong! i dont wanna boil him to death!:(



even if it IS my fault...........it still sucks.....;)
 
You'll probably find that you'll have to tweek the temp. set point to obtain the correct temp in the viv. Also a factor is the temperature surrounding the control box, the internal components tolerate with temperature. I find the best place to put the sensor is in a place that is inbetween the hot and cold spot on the floor of the viv.
 
You must log in or register to reply here.
Back
Top