• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Small Burn

and for further reference of the problem here is a photo of the burn or scrape in question.


CIMG3940_zpsb41f915b.jpg
 
Yes I have a vivarium electronics ve-300 model that is set to never go above 85 F. It will occasionaly go to 86F but I've never seen it go above that.
 
The tile doesn't have a fully clean cut and is a little rough which is why Alicia also mentioned it might be a scrap instead of a burn.
 
Yeah I checked on her today and the couple scales that flaked up fell away and the scrap has fully scabbed over. It looks like there's not going to be any permanent scarring and it should be completely okay in a few sheds at most.
 
Looks like Rapunzel's gone into blue phase so I should know later in the week how her healing and shed went.
 
You must log in or register to reply here.
Back
Top