• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Herpstat question

Blue Apple Herps

Blue Apple Herps

aka Matthew, PhD
How long is the probe on the Herpstat? I'm thinking about getting the Herpstat Pro as it's cheaper than getting 4 single ones, but need to make sure that the probes are long enough to reach to their respective heat source. Thanks.

Matthew
 
I'll measure mine when I get home. It's quite long. The company owner is really good at answering e-mails, too, but it's a holiday...

Nanci
 
The sensor/probe uses a 2 conductor wire with a mono 1/8" plug so it shouldn't be too hard to extend it if necessary.
 
You must log in or register to reply here.
Back
Top