• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Duct Tape on UTH

G

George the snake

New member
My UTH does not stick well at all to the tank, so I have been using lots of duct tape to hold it on. Is this safe, and does anyone have a better idea to make it stick?
 
I could be mistaken but I think it is the heat. You might need duct tape that is made for heat specificly.
 
George the snake said:
My UTH does not stick well at all to the tank, so I have been using lots of duct tape to hold it on. Is this safe, and does anyone have a better idea to make it stick?
Click to expand...

Not trying to beat a dead horse, but aluminum tape is the best way to go. You can apply a normal piece of aluminum foil where the sticky side used to be, and then tape the outer edge so it applies to your surface.
 
You must log in or register to reply here.
Back
Top